Cisco MDS 9500 Series Hardware Installation Manual page 158

Removing and Installing Clock Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Note
Verify the LEDs on the clock modules.
Step 3
Disconnect and gently remove the module, placing it on an antistatic mat or foam. (See
Step 4
Figure 2-41
Sheet metal
side
Step 5 Repeat
Cisco MDS 9500 Series Hardware Installation Guide
2-78
Note the position and orientation of the clock module before you remove it from the director
chassis because you must install the new clock module in the same position.
Clock Module Replacement on the Cisco MDS 9513 Director (Rear View)
Component
side
Step 3 and Step 4 to remove any additional clock modules.
Chapter 2 Installing the Cisco MDS 9500 Series
Figure 2-41.)
OL-19587-01