Installing A Clock Module Into The Cisco Mds 9513 Director - Cisco MDS 9500 Series Hardware Installation Manual

Chapter 2 Installing the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Installing a Clock Module into the Cisco MDS 9513 Director

Caution Always wear an ESD wrist strap when handling modules or coming into contact with internal
components.
To install the clock module, follow these steps:
Remove the new clock module from the antistatic bag (See
Step 1
Step 2 Hold the module with the backplane connectors away from you and the circuit board facing the right.
Figure 2-42
Carefully press the module onto the two matching connectors on the backplane.
Step 3
Note
Repeat
Step 4
Replace the back panel safety cover using the eight screws.
Step 5
Step 6 Provide power to the power supplies as described in the
page
Caution
Verify power supply operation by checking that the power supply LEDs are in the following states:
Step 7
•
•
OL-19587-01
Clock Module for the Cisco MDS 9513 Director
You must install the new clock module in the same position that you removed it.
Step 1 through Step 4
2-28.
In a system with dual power supplies, connect each power supply to a separate power source.
In case of a power source failure, the second source will most likely still be available.
INPUT OK LED is green.
FAN OK LED is green.
to install any additional clock modules.
Cisco MDS 9500 Series Hardware Installation Guide
Removing and Installing Clock Modules
Figure 2-42).
"Connecting the Power Supplies" section on
2-79