Installing The Switch On The Rack-Mount Support Brackets - Cisco MDS 9500 Series Hardware Installation Manual

Appendix B Cabinet and Rack Installation
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Step 4 Attach the crossbar to the shelf brackets as shown in
Step 5 Insert the slider rails into the shelf brackets as shown in
rack-mounting rails using a minimum of four 12-24 or 10-24 screws.

Installing the Switch on the Rack-Mount Support Brackets

This section provides general instructions for installing the switch on top of the rack-mount support
brackets. For detailed installation instructions, see the
section on page
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Before you install, operate, or service the system, see the Regulatory Compliance and Safety Information
Note
for the Cisco MDS 9000 Family for important safety information.
To install the switch on top of the rack-mount support brackets, follow these steps:
Step 1 Verify that the rack-mount support brackets are level and securely attached to the rack-mounting rails,
the support rack mount support brace is securely attached to the brackets, and the rack is stabilized.
Slide a mechanical lift under the switch and lift the switch up onto the rack-mount support brackets,
Step 2
ensuring it is squarely positioned.
Attach the switch to the rack-mounting rails. See the
Step 3
section on page
Caution
OL-19587-01
2-6.
2-6.
We recommend grounding the chassis, even if the rack is already grounded. There is a
grounding pad with two threaded M4 holes on the chassis for attaching a grounding lug.
Cisco MDS 9000 Family Telco and EIA Shelf Bracket
Figure B-2, using the 10-32 screws.
Figure B-2. Then attach them to the rear
"Installing the Chassis in a Cabinet or Rack"
"Installing the Chassis in a Cabinet or Rack"
Cisco MDS 9500 Series Hardware Installation Guide
B-11