Removing Mux/Demux Motherboards And Processor Cards; Installing Line Card Motherboards - Cisco ONS 15540 ESP Hardware Installation Manual

Installing and Removing Motherboards and Processor Cards

Removing Mux/Demux Motherboards and Processor Cards

Step 1
Step 2
Step 3
Step 4

Installing Line Card Motherboards

Step 1
Step 2
Step 3
Cisco ONS 15540 ESP Hardware Installation Guide
2-14
To remove the mux/demux motherboards and processor cards, follow these steps:
Remove all cables from the modules installed in the motherboard, if applicable,
or the processor card.
Install appropriate dust covers on the fiber cable connectors and the blind plugs
into the connectors on the motherboard or processor card.
Use a 3/16-inch flat-blade screwdriver to loosen the captive installation screws.
Use the captive installation screws to pull the motherboard or processor card out
of the slot in the chassis.
Place the removed motherboard or processor card in a container appropriate for
shipping and storage. To install a replacement motherboard or processor card, see
the "Installing Mux/Demux Motherboards and Processor Cards" section on
page 2-13.
To install a line card motherboard, follow these steps:
Remove the failed line card motherboard from the shelf.
Take the new line card motherboard from the shipping container.
Align the top of the line card motherboard and slide the line card motherboard into
the chassis slot. (See Figure
Chapter 2
2-6.)
Installing the Cisco ONS 15540
78-15095-01