Table of Contents
Advertisement
WARNING!
STUCCO OR OTHER NON-COMBUSTIBLE SURFACES ONLY.
The SimpliPHI Inverter wall bracket is designed to secure one SimpliPHI 6kW Inverter to a load bearing
surface. The bracket should be mounted directly to the load bearing wall. Mounting brackets should be
mounted into load bearing studs or solid materials with appropriate fasteners (mounting hardware not
included). A qualified installer should be familiar with accomplishing this with the appropriate load bearing
requirements. SimpliPhi Power is not liable for damage caused by the inappropriate installation of mounting of
brackets.
Wall brackets are designed to hold one SimpliPHI Inverter with a weight of 86 pounds. Do not hang from or use
a mounted inverter to support additional weight.
STEP 1: Secure the inverter wall bracket with at least 4 points of attachment. We strongly recommend
installing the bracket across two 16 in. standard spaced studs. The mounting brackets accommodate these
dimensions. To mount on a stud centered on the bracket please also use appropriate anchors, lags or toggles in
the corners of the bracket with no less than 4 total points of attachment (see below). We recommend using
3/8-16 hardware to secure the bracket on the wall.
STEP 2: Make sure the Keyhole on the inverter aligns with the 3/8-16 stud on the wall mount bracket. Secure
the Inverter on the wall mount bracket with 4 x 3/8-16 Serrated flange locknut (included with wall bracket).
4.4 – Sub-panel Installation & Wiring
© SIMPLIPHI POWER
FIRE HAZARD. SUITABLE FOR MOUNTING ON CONCRETE, BRICK,
Not Included
| 12 |
REV2022007071630
Advertisement
Table of Contents
