9.2 – Connecting to the Generator Input
WARNING!
BEFORE ATTEMPTING TO CONNECT THE UNIT.
Please follow below steps to implement generator input connection:
•
Before making generator input connection, be sure to open DC overcurrent protector or disconnect first.
•
Verify voltage on GEN terminals with a voltmeter prior to making connections.
•
Strip approximately ½" of the insulation on each of the conductors.
•
Insert AC input wires according to polarities indicated on terminal block and tighten the terminal screws.
1. GND (Ground) Green- to grounding bar
2. N (Neutral) White
3. L2 Red
4. L1 Black
9.3 – Dry Contact Signal
There is one dry contact available within the integrated distribution panel. This dry contact is utilized
for the automatic generator start (AGS) functionality.
Table 9.1: Electric Parameters
Parameter
Relay DC Voltage
Relay DC Current
© SIMPLIPHI POWER
BE SURE THAT THE GENERATOR POWER SOURCE IS DISCONNECTED
Symbol
VDC
IDC
| 23 |
Max
Unit
30
V
1
A
REV2022007071630