Daikin VRV RXYMQ-A Series Service Manual page 102

Field Settings for Indoor Unit
1.4.6 Dry Operation Time during VRTsmart Control
 If you switch the operation mode to "Dry" while VRTsmart is enabled, the mode will
Note 1) Increasing duration of dry operation degrades the energy efficiency
10 (20)
Note 2) When group control is enabled, all indoor units in the same group have a same set value for
duration of dry operation.
1.4.7 Low Airflow Setting when Thermostat OFF during VRTsmart Control
This setting changes the airflow volume to LL in coordination with the VRTsmart control when
cooling thermostat OFF is set. Also, the airflow direction is changed to horizontal.
When disabled:
12 (22)-6 (the airflow volume setting when cooling thermostat OFF is enabled)
13 (23)-7 (the swing setting when cooling thermostat OFF is enabled) is as set
When enabled: LL when Te ≥ 7°C
10 (20)
1.4.8 Indoor Fan Settings during Cooling/Heating Thermostat OFF
11 (21)
1.4.9 Setting of Airflow Rate when Heating
The fan revolution is changed to maintain the sufficient distance for warm air to reach during the
heating operation. The setting should be changed depending on the installation condition of the
unit.
11 (21)
Note that this setting is effective only during the heating operation.
96
automatically switch to "Cooling" after a certain period of time is elapsed.
If you want to increase the duration of dry operation, change the Second code No. as
indicated in the following table.
Mode First Second
No. Code No. Code No.
01
02
10
03
04
Mode First Code Second
No. No. Code No.
01
11
02
Mode Second Code
First Code No.
No.
2
Mode First Code Second Code
No. No.
3
Continuous (not returning to cooling)
No.
01
02
No.
01
02
03
SiME332106E
: Factory setting
Contents
30 minutes
60 minutes
90 minutes
: Factory setting
Contents
Disabled
Enabled
: Factory setting
Contents
Normal
Fan OFF
: Factory setting
Contents
Standard
Slightly increased
Increased
Part 5 Field Settings and Test Operation