Skoda Fabia II 2007 Workshop Manual page 125

– Release the nuts -1- and -2-.
Note
A second mechanic is needed under the vehicle to remove the
shift mechanism.
– Lower the shift mechanism together with the selector lever
control cable downwards and simultaneously guide the selec‐
tor lever control cable out of the cable support.
• Do not bend or buckle selector lever control cable.
The shift mechanism (only vehicles up to production date 05.2009
⇒ "2.1 Summary of components - Gearshift mechanism",
page 97 ) can also be replaced without selector lever control ca‐
ble. To do so the selector lever control cable must be separated
from the shift mechanism and the selector lever control cable
must be removed
⇒ "2.9 Removing and installing selector lever control cable, vehi‐
cles up to 05.2009 (Octavia II, Superb II, Yeti)", page 123
Vehicles Fabia II, Roomster
– Unhook rear silencer in such a way that it does not come in
contact with the rear axle.
– Clip off clips -arrows- and remove heat shield.
– Remove shift mechanism -arrow-.
• Do not bend or buckle selector lever control cable.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Vehicles Octavia II, Superb II, Yeti, Rapid NH
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
.
121
2. Shift mechanism