Remote Access - HP zx2000 Getting Started Manual

Setting Up and Using Your System

remote access

1–16
Use the up or down arrow keys to highlight an option, then press
Enter
.
EFI Shell [Built-in]
to operate the EFI commands or create and run automated scripts.
Boot Option Maintenance Menu
order of the devices from which you want the firmware to attempt
to boot the OS. You can also configure the system to boot from a
configuration file.
Security/Password Menu
system administrator and user passwords.
You can also access the EFI remotely.
1. With the workstation turned off, connect a 9-pin to 9-pin serial
cable to Serial Port A on the rear panel of the workstation, and to
your remote device.
2. Configure the terminal emulation software with these settings:
Baud rate: 9600
Bits: 8
Parity: None
Stop Bits: 1 (one)
Flow Control: XON/XOFF
3. Using the terminal emulation software, connect to the
workstation with a direct connection.
NOTE: The default terminal emulation type is VT100+. This setting
can be changed from the EFI
4. Turn on the workstation and follow the steps below to access
the EFI.
is a command line interface that allows you
allows you to select the
lets you add, change and delete
Boot Options Maintenance Menu
.
Getting Started Guide