Troubleshooting With The E-Buzzer - HP zx2000 Getting Started Manual

troubleshooting with the e-buzzer

Getting Started Guide
When your system starts up, the system firmware performs pre-boot
diagnostics to test your hardware configuration for any problems. If a
problem is detected during pre-boot, the e-buzzer emits audible beeps
and an encoded error message.
The e-buzzer emits a different number of beeps for each type of error.
More detailed information is provided by the system LEDs.
Number
of Beeps Component
1
Processor
2
Power Supply
3
Memory
4
Graphics Card Graphics card problem. Reseat or
5
PCI Card
6
General Failure Possible problems include: System board
7
System Board
Description
Processor absent, not correctly
connected. Reseat or replace processor.
Power supply failure. Replace power
supply.
No memory, bad memory modules or
incompatible memory module. Check
memory module loading order. Reseat or
replace memory modules.
replace the graphics card.
PCI card problem. Reseat or replace the
PCI card.
failure, CPU connection problem,
CPU failure, CPU power failure.
See the hp zx2000 Technical Reference
Guide for additional details and
recommendations.
Defective system board. Contact support.
Troubleshooting
2–9