Solenoid Hood (Smart Cover) Lock (Optional); Front Bezel - HP xw4300 Service And Technical Reference Manual

4.11 Solenoid Hood (Smart Cover) Lock (Optional)

To remove the solenoid lock:
1. Disconnect power from the system
2. Disconnect the solenoid hood lock cable 1 from the system board.
3. Using the FailSafe key (T-15 wrench), unscrew the two screws 2 from the back of the chassis as shown in the
following diagram.
To purchase a FailSafe key, contact your authorized HP reseller or service provider or visit the HP Web site
(http://www.hp.com) for ordering information.
4. Slide the solenoid hood lock assembly 3 away from the chassis and out of the unit.
To replace the solenoid hood lock assembly, reverse the previous steps.

4.12 Front Bezel

To remove the front bezel:
1. Disconnect power from the system
2. Lift up on the two tabs 1 located on the front bezel.
3. Rotate the front bezel away 2 from the chassis and remove the bezel.
To replace the front bezel, reverse the previous steps.
(section 4.2) and open the access panel
(section 4.2) and open the access panel
(section 4.9).
(section 4.9).
61