HP xw4300 Service And Technical Reference Manual page 79

4. After pulling the drive 1 out, remove the four guide screws 2 from the drive. Only remove the four guide screws
if you plan to install another drive.
To install an optical drive:
1. Disconnect power from the system
(section 4.12), and remove a bezel blank
2. Insert the four guide screws 1 into the drive.
3. Align the screws with the grooves in the drive bay and gently slide 2 the drive into the unit until it snaps into
place.
CAUTION: Ensure that the optical drive is secure by pulling to see if the drive can become easily disengaged. Failure
to do so can cause damage to the drive when moving the workstation.
4. Connect the power, drive, and audio (if required) cables to the drive and system board. On Linux systems,
connect the audio cable to the AUX-IN connector.
NOTE: The audio cable is only required for Linux-based systems.
(section 4.2), open the access panel
(section 4.13), if necessary.
(section 4.9), remove the front bezel
79