Bezel Blanks - HP xw4300 Service And Technical Reference Manual

4.13 Bezel Blanks

To remove the bezel blank:
1. Disconnect power from the system
(section 4.12).
2. Gently push the subpanel 1 out the back of the front bezel.
3. Remove the desired bezel blank by applying outward pressure on the subpanel 1 and pulling the blank 2 away.
NOTE: The bezel blanks are keyed to assist you in replacing the blanks. Also, the subpanel can be rotated 90 degrees
to install the optical drives in desktop orientation, if desired.
62 Removal and Replacement Procedures
(section 4.2), open the access panel (section 4.9), and remove the front bezel