Hood Lock (Smart Cover Lock) (Optional) - HP Xw6200 - Workstation - 2 GB RAM Technical Reference Manual

4 Push the hood sensor down and remove it from the chassis.
To replace the hood sensor, reverse the previous steps.

Hood Lock (Smart Cover Lock) (Optional)

To remove the hood lock:
1 Disconnect power from the system
cover (page 76) and lay the workstation on its side with the system board facing up.
2 Using the FailSafe Key (included with the kit), remove the two tamper-resistant screws that secure
hood lock to the chassis.
3 Disconnect the hood lock cable from the system board and remove the lock assembly.
To install the hood lock, reverse the previous steps.
(page 68), remove the access panel
REMOVAL AND REPLACEMENT OF COMPONENTS 77
(page 74), remove the top