Connecting The Storage Tray Cables - HP Visualize b132L Owner's Manual

B_configure.doc 159 Thu Jul 11 10:48:31 1996
Figure 62
12 Reconnect the floppy, SE SCSI, power, CD-ROM audio, and FW SCSI cables as
shown in Figure 62.
When connecting the floppy cable to the system board, use the following proce-
dure:
a Lift the locking ring on the connector to the up, or unlocked, position.
b While holding the locking ring in the unlocked position, insert the cable into
the connector until the blue line is even with the locking ring.
c Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.
FWSCSI
Storage Tray
Power
SESCSI
CD Audio
Floppy Connector

Connecting the Storage Tray Cables

13 Follow the instructions in Replacing the Main Tray Assembly on page 110.
Changing Your Workstation's Hardware Configuration
Replacing the Battery
159