Preparing To Install Your Storage Device; Configuring Your Storage Device; Determining Your Storage Devices Position; Default Scsi Ids - HP Visualize b132L Owner's Manual

B_configure.doc 113 Thu Jul 11 10:48:31 1996
Table 15
NOTICE:

Preparing to Install Your Storage Device

This section describes information that you need to consider and procedures
that you need to perform before installing any storage device.
Configuring your Storage Device
Table 15 lists the recommended SCSI IDs for internal storage devices. If an
existing device already uses one of the suggested IDs, select an alternate ID.

Default SCSI IDs

Fast, Wide SCSI
1st Hard Disk Drive
2nd Hard Disk Drive
Note: The Fast, Wide SCSI controller is set to
SCSI ID 7.
Single-Ended SCSI
CD-ROM Drive
DDS Drive
1st Hard Disk Drive
2nd Hard Disk Drive
Notes: The floppy drive is NOT a SCSI device.
Each SCSI controller uses SCSI ID 7.
The floppy disk drive is not a SCSI device.
Set the jumpers and SCSI IDs according to the installation instructions that
came with your device.

Determining Your Storage Devices Position

Each storage device is restricted as to where in the storage tray it may be
installed. Before installing a storage device, use Figure 23 and Table 16 to
determine which disk tray position is correct for your device.
Figure 23 shows the storage device positions in the disk tray. Table 16 lists
what devices are supported in the different disk tray positions. The numbers
in the table's left column refer to the position numbers in Figure 23.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
ID 6
ID 5
ID 2
ID 3
ID 6
ID 5
113