Connecting And Disconnecting Cables; Connecting Cables; Connecting A Monitor - HP ProOne 600 Hardware Reference Manual

5. To attach the computer to a swing arm (sold separately), insert the four 20 mm screws that are supplied
with the computer through the holes on the swing arm plate and into the mounting holes on the
computer.
To attach the computer to other mounting fixtures, follow the instructions included with the mounting
fixture to ensure that the computer is safely attached.

Connecting and disconnecting cables

Connecting cables

1. Connect the peripheral cables to the appropriate ports.
2. Connect the power cord to the power connector on the rear of the computer.

Connecting a monitor

The ports on the rear of the computer allow you to connect up to two monitors to the computer.
If you are adding a monitor that has a DisplayPort connector, no video adapter is required. If you are adding a
monitor that does not have a DisplayPort connector, you can purchase a video adaptor from HP for your
configuration.
DisplayPort adapters and video cables are purchased separately. HP offers the following adapters:
DisplayPort-to-VGA adapter
●
DisplayPort-to-DVI adapter
●
To connect a monitor:
1. Turn off power to the computer and to the monitor that you are connecting to the computer.
2. If your monitor has a DisplayPort connector, connect a DisplayPort cable directly between the
DisplayPort connector on the rear of the computer and the DisplayPort connector on the monitor.
3. If your monitor does not have a DisplayPort connector, connect a DisplayPort video adapter to the
DisplayPort connector on the computer. Then connect a cable (VGA or DVI, depending on your
application) between the adapter and the monitor.
4. Turn on power to the computer and the monitor.
NOTE: Use the graphics card software or the Windows Display Settings to configure the monitor as a
mirrored image of the computer display or an extension of the computer display.
Connecting and disconnecting cables 13