B_configure.doc 162 Thu Jul 11 10:48:31 1996
Figure 64
Changing Your Workstation's Hardware Configuration
Installing the Optional Fast Wide SCSI Controller
Installing the Optional Fast Wide SCSI Controller
Before you can install the FW SCSI controller you must perform the proce-
dure described in Removing the Main Tray Assembly on page 109.
Perform the following procedure to install the FW SCSI controller:
1 Install the three standoffs, as shown in Figure 64.
2 Line up the connector on the FW SCSI controller and the connector on the CPU
board while at the same time aligning the standoffs to the holes in the FW SCSI
controller, as shown in Figure 64.
Installing the Optional FW SCSI Controller
162