B_configure.doc 165 Thu Jul 11 10:48:31 1996
To FW SCSI Controller
Figure 67
6 Connect the end of FW SCSI cable to the FW SCSI controller making sure that
the red line on the cable is toward the rear (away from the fans) of the main tray,
as shown in Figure 67.
Ferrite Bead
Cable Clip
Installing the FW SCSI Cable
7 Set the ferrite bead into the slot on the side of the storage tray. Make sure that the
cable is dressed so that it will not be damaged by the storage tray cover
8 Use the two hex standoffs to install the external connector on the end of the FW
SCSI cable into the rear panel of the storage tray, as shown in Figure 67.
9 Secure the cable in the cable clip so that it does not interfere with the disk drives,
as shown in Figure 67.
Changing Your Workstation's Hardware Configuration
Installing the Optional Fast Wide SCSI Controller
Red Line
External Connector
165