Connecting And Disconnecting Cables; Connecting Cables; Connecting A Display - HP EliteOne 800 G3 Hardware Reference Manual

Connecting and disconnecting cables

Connecting cables

1. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket, towel,
or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2. If the rear port cover is installed, remove the cover.
See Removing the rear port cover on page
3. Route the power and all peripheral cables through the opening in the base of the stand.
4. Connect the peripheral cables to the appropriate ports.
5. Replace the rear port cover.
See Installing the rear port cover on page
6. Connect the power cord to the power connector on the rear of the computer.

Connecting a display

The DisplayPort and HDMI connectors on the rear of the computer allow you to connect displays to the computer.
If your computer has Intel graphics, you may connect up to two displays in one of the following
●
configurations:
Two displays daisy-chained to the DisplayPort
—
One display connected to the DisplayPort and one to the HDMI port
—
If your computer has AMD graphics, you may connect up to four displays in one of the following
●
configurations:
All four displays daisy-chained to the DisplayPort
—
Three displays daisy-chained to the DisplayPort and one connected to the HDMI port
—
If you are adding a display that has a DisplayPort or an HDMI connector, then no video adapter is required. If you
are adding a display that does not have a DisplayPort or HDMI connector, you can purchase a video adaptor from
HP for your configuration.
12.
13.
Connecting and disconnecting cables 11