Scsi Configuration Constraints; Se Scsi Bus Configuration Constraints; Se Scsi Bus Configuration Constraints - HP Visualize b132L Owner's Manual

C_scsi.doc 175 Thu Jul 11 10:49:09 1996
Table 20
Hard Disk Drives (two internal)
CD-ROM Drives (one internal
4-mm DDS Tape Drives (one internal)
9-track Tape Drives
650-MB Magneto-Optical Drives
Magneto-Optical Autochangers (see notice below)
Maximum Number of SE SCSI Devices
NOTICE: Magneto-Optical Autochangers use three SE SCSI drive address. Each address
SCSI Configuration Constraints
You are limited to the number of same-type SCSI devices per system. Before
adding another SCSI device, determine if the system can support the addi-
tional device.
This workstation offers the following types of SCSI bus, each with its own
configuration constraints:
• SE SCSI bus
• Optional FW SCSI bus

SE SCSI Bus Configuration Constraints

For the SE SCSI bus, HP-UX supports only one of each type of removable
disk drive and two of the same type tape devices per system. Table 20 shows
configuration constraints for each SE SCSI device type. If the system has an
internal CD-ROM drive, tape drive or hard disks connected to the SE SCSI
bus, you must count them as SE SCSI devices.
SE SCSI Bus Configuration Constraints
SE SCSI Devices
must be accounted for in the maximum number of SE SCSI devices allowed.
SCSI Connections
SCSI Restrictions
Maximum Number of Each
Type of Device Allowed
7
1
2
2
1
1
7
175