B_configure.doc 110 Thu Jul 11 10:48:31 1996
Thumbscrews
Figure 22
NOTICE:
Changing Your Workstation's Hardware Configuration
Replacing the Main Tray Assembly
Replacing the Main Tray Assembly
Perform the following steps to replace the main tray assembly:
1 Align the main tray assembly with the chassis and slide it into place, as shown in
Figure 22.
Replacing the Main Tray Assembly
2 Slide the main tray in until it is fully seated in the chassis.
3 Tighten the four thumbscrews, as shown in Figure 22.
To maintain regulatory agency compliance, verify that the main tray is
fully seated and all four thumb screws are completely tightened.
110
Thumbscrews