Installing And Upgrading Removable Media Devices - HP Vectra VEi7 Supplementary Manual

WARNING
NOTE

Installing and Upgrading Removable Media Devices

To avoid electric shock and harm to your eyes by laser light, do not
open the laser module. The laser module should be serviced by service
personnel only. Do not attempt to make any adjustment to the laser
unit. Refer to the label on the CD-ROM drive for power requirements
and wavelength. This product is a class 1 laser product.
The PC has an integrated Enhanced IDE controller which supports up
to three IDE devices. Removable media IDE devices, such as CD-ROM
drives, DVD drives, tape drives and Zip drives, require front access.
You can install a removable media IDE drive in an empty front shelf.
1 Remove the PC's cover and front panel (described in this chapter).
If your drive is supplied with three retaining screws, you must first
remove the floppy/hard disk drive tray in order to install your new drive.
2 Remove the drive tray (if required) by undoing the three retaining
screws, and then sliding the tray back by about 3 cm (1.2 inches)
until it can be lifted out.
2 How to Install and Upgrade Accessories In Your PC
Upgrading Mass Storage Devices
55