JETWAY NF731V Series User Manual page 42

Use this item to enable or disable this USB physical connector (physical port).
Once disabled, any USB devices plugged into this connector will not be detected
by BIOS or OS.
The optional settings are: [Disabled]; [Enabled].
Onboard Lan1 Controller
Use this item to enable or disable Lan1 onboard NIC.
The optional settings are: [Enabled]; [Disabled].
When 'Onboard Lan1 Controller' set as [Enabled], the following sub-items shall
appear:
Wake on LAN
Use this item to enable or disable integrated LAN to wake the system
The optional settings are: [Enabled]; [Disabled].
Onboard Lan2/3/4 Controller
Use this item to enable or disable Lan2/3/4 device or controller.
The optional settings are: [Enabled]; [Disabled].
MPE1 Slot
Use this item to enable or disable device or controller.
The optional settings are: [Disabled]; [Enabled].
Speed
The optional settings are: [Auto]; [Gen1]; [Gen2]; [Gen3].
MPE2 Slot
Use this item to enable or disable device or controller.
The optional settings are: [Disabled]; [Enabled].
Speed
The optional settings are: [Auto]; [Gen1]; [Gen2]; [Gen3].
System State After Power Failure
Use this item to specify what state to go to when power is re-applied after a power
loss (G3 State).
The optional settings are: [Always On]; [Always Off]; [Former State].
* The option [Always On] and [Former State] are affected by ERP function. Please
disable 'ERP Support' to support [Always On] and [Former State] function.
37