JETWAY NF731V Series User Manual page 29

The optional settings are: [Enabled]; [Disabled].
Hot Plug
Use this item to designates this port as Hot Pluggable
The optional settings are: [Enabled]; [Disabled].
 PCH-FW Configuration
Press [Enter] to view ME information and make settings in the following sub-items:
TPM Device Selection
Use this item to select TPM device: PTT or dTPM.
The optional settings are: [dTPM]; [PTT].
Warning! PTT/ dTPM will be disabled and all data saved on it will be lost
Firmware Update Configuration
▶
Press [Enter] to make settings for 'ME FW Image RE-Flash'.
ME FW Image Re-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
* In the case that user needs to update ME firmware, user should set 'ME FW
Image Re-Flash' as [Enabled], save the settings and exit. The system will turn off
and reboot after 4 seconds. If the user goes to BIOS screen again will find this item
is set again as [Disabled], but user can still re-flash to update firmware next time.
 Trusted Computing
Press [Enter] to enable or disable 'Security Device Support'.
Configuration
Security Device Support
Use this item to enable or disable BIOS support for security device. O.S. will not
show Security Device. TCG EFI protocol and INT1A interface will not be available
The optional settings: [Disabled]; [Enabled].
NO Security Device Found
 ACPI Settings
Press [Enter] to make settings for the following sub-item:
ACPI Settings
.
24