JETWAY NF731V Series User Manual page 35

[Odd]: parity bit is 0 if num of 1's in the data bits is odd.
[Mark]: parity bit is always 1.
[Space]: parity bit is always 0.
Mark and Space Parity do not allow for error detection.
The optional settings are: [None]; [Even]; [Odd];[Mark]; [Space].
Stop Bits
Use this item to stop bits indicate the end of a serial data packet. (A start bit
indicates the beginning). The standard setting is 1 stop bit . Communication
with slow devices may require more than 1 stop bit
The optional settings are: [1]; [2].
Flow Control
Use this item to flow control can prevent data loss from buffer overflow .When
sending data, if the receiving buffers are full, a 'stop' signal can be sent to stop
the data flow. Once the buffers are empty, a 'start' Signal can be sent to re-start
the flow. Hardware flow control uses two wires to send start/stop signals.
The optional settings are: [None]; [Hardware RTS/CTS].
VT-UTF8 Combo Key Support
Use this item enable VT-UTF8 combination key support for ANSI/VT100
terminals.
The optional settings are:[Disabled]; [Enabled].
Recorder Mode
Use this item with this mode enabled only text will be sent. This is to capture
Terminal data.
The optional settings are: [Disabled]; [Enabled].
Resolution 100x31
Use this item enables or disables extended terminal resolution
The optional settings are:[Disabled]; [Enabled].
Legacy OS Redirection Resolution
Use this item on Legacy OS, the number of Rows and Columns supported
redirection
The optional settings are: [80x24]; [80x25].
30