JETWAY NF731V Series User Manual page 37

Use this item to selects serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings are: [9600]; [19200]; [57600]; [115200].
Flow Control
Use this item to flow control can prevent data loss from buffer overflow. When
sending data, if the receiving buffers are full, a 'stop' Signal can be sent to stop
the data flow. Once the buffers are empty, a 'start' signal can be sent to re-start
the flow. Hardware flow control uses two wires to send start/stop signals.
The optional settings are: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
 Network Stack Configuration
Press [Enter] to go to 'Network Stack' screen to enable or disable UEFI Network
Stack.
Network Stack
The optional settings are: [Enabled]; [Disabled].
When set as [Enabled], the following sub-items shall appear:
Ipv4 PXE Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv4 PXE Boot Support. When set as [Disabled], Ipv4 boot
option will not be created.
Ipv4 HTTP Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv4 HTTP Boot Support. When set as [Disabled], Ipv4
32