Replacing The Floppy Disk Drive - HP Kayak xu700 User Manual

Minitower

Hide thumbs Also See for Kayak xu700:

Table of Contents

Removing the

Floppy Disk Drive

Installing the Floppy

Disk Drive

Replacing the Floppy Disk Drive

Switch off the display and PC Workstation. Disconnect all power cables

and any LAN or telecommunications cables.

Remove the PC Workstation's cover and front upper bezel (refer to page

26 for these instructions).

Disconnect the power and data cables from the old drive.

Remove the drive. To do this, press the two front clips inward and,

pushing from the rear, slide out the drive.

Remove the two short green guide rails by gently prying them off the

drive. These guide rails will be required for the new drive.

Add the short green guide rails to the new drive. Insert the guide rail

labeled "L" on the left-hand side (cable connectors facing towards you

and positioned at the top), and the guide rail "R" on the right-hand side

of the hard disk drive.

Align the guide rails on both sides of the drive with the internal shelf

guides, then slide the drive until it clicks into position.

Connect the power and data cables to the new drive and any installed

drives. The connectors are shaped to go in one way only.

Replace the front bezel and PC Workstation's cover (refer to page 26).

Reconnect all the power and telecommunications cables.

Turn to page 42 to complete the installation.

2 Installing and Replacing Hardware Parts in Your PC Workstation

Replacing the Floppy Disk Drive

Table of Contents