Installing A Second Hard Disk Drive In An Internal Shelf - HP Kayak xu700 User Manual

Installing the
New Drive
NOTE
2 Installing and Replacing Hardware Parts in Your PC Workstation

Installing a Second Hard Disk Drive in an Internal Shelf

1 Add the short blue guide rails to the new hard disk drive. Insert the guide
rail labeled "L" on the left-hand side (cable connectors facing towards
you and positioned at the bottom), and the guide rail "R" on the right-
hand side of the hard disk drive.
2 The hard disk drive can only be inserted one way. Ensure that the data
and cable connectors are facing you and positioned at the top.
3 Align the guide rails on both sides of the drive with the internal shelf
guides and then slide the drive in until it clicks into position.
Avoid trapping or disconnecting the hard disk drive bay thermal sensor
cable. If this cable becomes disconnected, reconnect it to the system board
connector marked T T T T H H H H E E E E R R R R M M M M A A A A L L L L _ _ _ _ S S S S E E E E N N N N S S S S O O O O R R R R (positioned near the IDE and
Floppy data cable connectors.
4 Connect the power cable and the data cable to the new hard disk drive.
The connectors are shaped to go in one way only. If you are not sure
which connector to use, refer to "Installing Mass Storage Devices", on
page 31.
5 Replace the PC Workstation's cover (refer to page 26). Reconnect all the
power and telecommunications cables.
6 Turn to page 42 to complete the installation.
Installing a Second Hard Disk Drive in an Internal Shelf
The internal hard disk shelves, located just under the floppy drive, can
support two 3.5-inch devices.
To install a second hard disk drive:
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover (refer to page 26 for instructions).
3 If the primary hard disk drive is installed in the top shelf, disconnect the
data and power cables.
4 Attach the short blue rails (found on the CD cage) to the new hard disk
drive. Insert the guide rail labeled "L" on the left-hand side (cable
connectors facing towards you and positioned at the bottom), and the
guide rail "R" on the right-hand side of the hard disk drive.
5 The second hard disk drive can only be inserted one way. Ensure that
the data and cable connectors are facing you and positioned at the top.
36