Replacing The System Fan - HP Kayak xu700 User Manual

NOTE
2 Installing and Replacing Hardware Parts in Your PC Workstation

Replacing the System Fan

Replacing the System Fan
Removing the Fan
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover (refer to page 25 for instructions).
3 Holding the fan with one hand, use a screwdriver to gently push the
retaining clips in the direction shown by the arrows on the chassis, then
slide the fan up and out of the chassis.
4 Disconnect the fan connector from the C C C C H H H H A A A A SS
board.
Replacing the Rear Fan
Ensure that all cables are clear of the fan and will not easily come into
contact with the fan during normal use or following transportation.
1 The fan unit can only be installed in one way. The distance between the
two retaining clips is shorter at the top than the bottom. Align the fan
clips with their corresponding holes.
2 Gently push the fan downwards until it clicks into place.
3 Connect the fan connector to the C C C C H H H H A A A A S S S S S S S S I I I I S S S S _ _ _ _ F F F F A A A A N N N N socket on the system
board.
4 Replace the PC Workstation's cover (refer to page 26). Reconnect all the
power and telecommunications cables.
52
SSI I I I S S S S _ _ _ _ F F F F A A A A N N N N socket on the system
SS SS