Installing A Third Or A Fourth Hard Disk Drive - HP Kayak xu700 User Manual

NOTE
6 Align the guide rails on both sides of the drive with the internal shelf
guides and then slide the drive into the bottom shelf until it clicks into
position.
Avoid trapping or disconnecting the hard disk drive bay thermal sensor
cable. If this cable becomes disconnected, reconnect it to the system board
connector labeled T T T T H H H H E E E E R R R R M M M M A A A A L L L L _ _ _ _ S S S S E E E E N N N N S S S S O O O O R R R R (positioned near the IDE and
Floppy data cable connectors.
7 Connect the power and data cables to the second hard disk drive.
Reconnect the power cables and the data cable to the primary hard disk
drive.
8 Replace the PC Workstation's cover (refer to page 26). Reconnect all the
power and telecommunications cables.
9 Turn to page 42 to complete the installation.

Installing a Third or a Fourth Hard Disk Drive

A third and a fourth 3.5-inch hard disk drive can be installed in the 5¼-inch
front access shelves using a hard disk drive tray kit. The tray kit is supplied
as an accessory and can be ordered separately.
The following table shows the hard disk drive speeds supported in your PC
Workstation.
1st HDD
2nd HDD
3rd HDD
4th HDD
2 Installing and Replacing Hardware Parts in Your PC Workstation
7.2 Krpm
Installing a Third or a Fourth Hard Disk Drive
10 Krpm 15 Krpm
37