HP Kayak xu700 User Manual page 49

CAUTION
Installing the New System Board
1 Clip the retaining metal bracket onto the new system board.
2 Aligning the rear connectors with their corresponding sockets, insert the
system board and lower it onto the guide pins. Ensure that all hooks are
correctly positioned. Check that the rear connectors are correctly
aligned in their sockets.
When inserting the system board, be careful not to damage or bend the metal
fingers on the rear connector EMI shield. If the shield is damaged it can be
very difficult to install the system board correctly.
3 Replace the rear screw to secure the system board in place.
4 Replace the two screws located next to the processor socket.

5 Reconnect any cables you disconnected earlier from the system board.
Note that there are three power connectors on the system board – you
must connect all of them. To find out the positions of system board
connectors, refer to page 55 or to the label located on the inside of the
cover.
6 Replace the main memory, processor, heatsink and any accessory cards
in the new system board (described in this chapter). When reinstalling
the heatsink, remember to replace the thermal interface.
2 Installing and Replacing Hardware Parts in Your PC Workstation

Replacing the System Board


49