Viewdata Mode - HP Compaq t5725 User Manual

Getting Started
The VT400 Series-7 and VT400 Series-8 emulations enable you to run applications
written for the DEC VT400 terminal, the difference is in their treatment of 8-bit
control codes. When VT400 Series-7 is selected, all 8-bit codes are converted to their
7-bit equivalents, whereas VT400 Series-8 leaves 8-bit codes unchanged. If you are
using VT200 applications, select VT400 Series-7. Refer to the DEC VT Emulations
chapter for more information.
The WYSE 50, 50+ and 60 emulations provide compatibility with software designed
to drive the Wyse WY-50, WY-50+ and WY-60 terminals, respectively. Refer to the
Wyse Emulations chapter for information on these emulations.
Graphics Emulations
The 4010/4014 emulation enables you to run applications written for the Tektronix
4010 and 4014 terminals.
The Regis emulation enables you to run applications written for the DEC VT340
terminal in ReGIS mode.
The VT640 emulation enables you to run applications written for the Retrographics
VT640 terminal.
The Westward 2119 emulation enables you to run applications written for the
Westward 2119 terminal.

Viewdata Mode

TeemTalk enables you to select one of three display formats for viewdata mode: 40
column, 80 column, or Split Screen. Selecting Viewdata 40 or Viewdata 80 mode
will enable a single viewdata page of 40 or 80 columns wide by 24 lines deep to be
displayed.
Viewdata Split enables simultaneous display of two pages side by side, each page
consisting of 24 lines and 40 columns. Receipt of a clear screen command will move
the cursor to the home position of the opposite page and its contents will be erased
ready for the next page.
The keys mapped as PF1 through PF4 have the following functions in viewdata
mode:
2-4
PF1: * PF3: Reveal
PF2: # PF4: Exit to ANSI mode