HP Compaq t5725 User Manual page 89

Setup Menus
EscXfer
Factory default: Unselected
The setting of this option determines whether escape sequences relating to the display
are sent when the display memory is transferred to the printer.
When unselected, escape sequences relating to the display are not sent to the printer.
When selected, each line transferred to the printer will begin with an escape sequence
to select the primary character set and stop any character enhancements. When escape
sequences relating to the display are encountered within the data (for example, to
change the character set), they will be sent to the printer.
CR=CR/NULL
Factory default: Unselected
This option must only be selected if you are going to use the QEDIT application. It
overcomes a bug within QEDIT that ignores the LF character if the terminal transmits
CR/LF. Inserting a NULL after the CR character cures the problem.
Terminal ID
Factory default: HP70092
This specifies what is reported back to the host in response to a terminal identification
request. (Note that not all features of the specified terminal may be supported.)
XmitFnctn (A)
Factory default: Unselected
This option determines whether escape sequences generated by control and function
keys are sent to the host or only to the terminal emulation.
When unselected, escape sequences are only sent to the terminal emulation.
When this option is selected, escape sequences are sent to the host. If the Local Echo
option is selected, the sequences will also be sent to the terminal emulation.
SPOW (B)
Factory default: Unselected
The setting of the SPace OverWrite option determines whether keyboard entered
spaces overwrite existing characters or not.
When this option is unselected, keyboard entered spaces will overwrite existing
characters. Selecting this option will cause the SPOW latch to be enabled. The latch
can then be activated by a carriage return. When activated, keyboard entered spaces
will cause the cursor to move forward without deleting characters that already exist.
The latch can be deactivated by a tab, line feed or home-up command. This will cause
spaces to overwrite existing characters as normal.
6-43