HP Compaq t5725 User Manual page 90

Setup Menus
InhEolWrp (C)
Factory default: Unselected
The Inhibit End of line Wrap option determines whether characters wrap to the next
line when the right margin is reached. When selected (i.e. inhibited), on reaching the
right margin, the last character position will be overwritten with every new character
received until a carriage return or other cursor movement command is issued.
Page Mode (D)
Factory default: Unselected
The setting of this option determines whether data is sent a line or a page at a time
when in Edit mode.
When this option is unselected, data will be transmitted a line at a time. When selected,
data will be transmitted a page at a time. Page data will either be from the beginning of
display memory or from the current cursor position.
InhHndShk (G)
InhDC2 (H)
Factory default: Unselected
The combined setting of these two options determine the type of handshaking used
when blocks of data are transmitted to the host.
One of three types of handshake may be used:
1. No handshake. Blocks of data are sent immediately when the
relevant transmit key is pressed.
2. DC1 handshake. Data is only sent to the host when the host sends
an ASCII DC1 control code to request it.
3. DC1/DC2/DC1 handshake. The host sends an ASCII DC1 control
code, to which TeemTalk replies by sending a DC2 code if ready
to transmit. The host sends the DC1 code again to cause the data
block to be transmitted.
The type of handshake used for block transfers is determined by the type of block
transfer to be performed, the current operating mode (character, block line, block page,
or modify mode), and the setting of these two options.
The setting of these two options will have the following general effect:
InhHndShk only selected:
InhDC2 only selected:
InhHndShk and InhDC2 selected:
6-44
DC1/DC2/DC1 handshake or no handshake will be used.
The DC1 handshake or no handshake will be used.
No handshake will be used.