HP Compaq t5725 User Manual page 86

Setup Menus
When unselected, the keys will generate characters corresponding to the legends on the
keycaps (or their stored strings if they have been programmed). When this option is
selected, the keys will generate control functions when pressed.
Note: On some keyboards these keys act as both a numeric keypad
Save Screen Before Clearing
Factory default: Unselected
This applies to all DEC 'VT' emulations except VT340 and VT420. It determines the
effect of a clear screen command received from the host. When unselected, the con-
tents of the current page will be cleared. When selected, the contents of the current
page will be saved and the display will scroll to the next page.
Save Scrolled Lines
Factory default: Unselected
If a scroll region is set, selecting this DEC VT emulation option will cause data
scrolled out of the region to be stored in a history buffer.
Use 80 Column Font
Factory default: Unselected
This DEC VT emulation option specifies which font to use when the Number Of
Columns option is set to 132. When unselected, a narrow font will be used so that all
132 columns are visible in the window. When selected, only 80 columns will be
visible using the normal font, with the remaining columns stored off-screen. You can
scroll horizontally to view the hidden columns by holding down the Ctrl key and
pressing the Left or Right Cursor keys.
Page Width = 132
Factory default: Unselected
This DEC VT emulation option specifies the width of display memory as 80 columns
when unselected or 132 columns when selected. When the Number Of Columns
setting is less than the page width specified here, you can scroll horizontally to view
the hidden columns by holding down the Ctrl key and pressing the Left or Right
Cursor keys.
Tertiary Device Attribute
Factory default: Unspecified
When TeemTalk is in VT420 mode (Alpha Emulation set to VT400 and Terminal
ID set to VT420), this option enables you to specify the tertiary device attribute report
that is sent in response to a request from the host.
6-40
and a cursor key block depending on the setting of a
modifier, for example the Num Lock key. The Application
Keypad Mode setting only affects the characters generated
when the keys are acting as a numeric keypad.