Assembly - Pro-Form 690 HR User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
wrench , and a rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M4 Split
M4 Washer
Washer
(102)–8
(112)–8
M10 Locknut
M8 Jam Nut
(79)–5
M4 x 47mm
Screw (108)–2
M8 x 23mm Shoulder
Screw (115)–4
M8 x 69mm Button
Bolt (80)–1
All manuals and user guides at all-guides.com
M8 Split
Washer (90)–3
M4 x 16mm
Screw (104)–8
(81)–2
Transport Handle
Screw (117)–4
M8 x 23mm Button
Screw (84)–4
M10 x 127mm Button Screw (83)–2
.
Wave Washer
M8 Washer
(111)–2
M4 x 16mm
Round Head
Screw (101)–8
M8 x 41mm Button
M10 x 80mm Carriage
5
, an adjustable
Bearing Spacer
(118)–4
(88)–6
M4 x 32mm
Round Head
Screw (105)–6
Hub Screw (87)–8
Bolt (78)–4
Bolt (82)–2