6.10 Speaker
1. Prepare the computer for disassembly
2. Remove the right access panel
3. Remove the front bezel
4. Disconnect the speaker cable from the system board 1.
5. From the outside of the chassis pull out the stems of the four push pins to release the
speakers then, remove the speaker 2.
When installing the speakers, hold the plastic pin retainers firmly in place as they tend to be
pushed out of the chassis holes when the speaker is being positioned. Once a speaker mounting
hole has been properly aligned and the pin retainer pressed into it, insert the push pin to secure
the pin retainer. To ensure proper alignment, install the push pins in an X pattern.
Service Reference Guide, d200
Removal and Replacement Procedures— Microtower Type 2 Chassis
(Section 6.1, "Preparation for
(Section 6.2, "Access
(Section 6.3, "Front
Bezel").
336493-004
Disassembly").
Panel").
6–17