HP Compaq d220 MT Reference Manual page 16

Setup Utilities and Diagnostics Features
Heading Option
Power Resume on LAN
Management (d220, d228, and
Setup d230 models only)
(Continued)
Resume on PME
Peripheral OnBoard LAN
Setup
OnBoard LAN
Chip Boot ROM
Init. Graphics
Adapter Priority
USB Controller
USB 1.1 Device
Legacy Support
OnBoard Serial
Port
✎
Support for Computer Setup options may vary depending on your specific hardware configuration.
2–6
Sets the Resume On LAN from soft off.
• Disable: LAN Resume disable
• Enable: LAN Resume enable (default)
Sets the Resume On PME from soft on.
• Disable: PME Resume disable
• Enable: PME Resume enable (default)
Enables or disables the OnBoard LAN.
• Disable: OnBoard LAN disabled
• Enable: OnBoard LAN enabled (default)
Enables or disables the OnBoard LAN Chip Boot ROM.
• Disable: OnBoard LAN Chip Boot ROM disabled
• Enable: OnBoard LAN Chip Boot ROM enabled (default)
Sets the initial priority of the graphics adapter
NR 138 GE (d220, d228)
• AGP/Int-VGA
• AGP/PCI (default)
• PCI/AGP
• PCI/Int-VGA
NR 138 GV (d230)
• PCI/Int-VGA (default)
NR 146 GV (d240, d248)
• PCI/Int-VGA (default)
• Int-VGA/PCI
Enables or disables the USB controller.
• Disable: USB controller disabled
• Enable: USB controller enabled (default)
Sets the USB 1.1 Device Legacy Support under DOS mode.
• Disable: USB 1.1 Device Legacy Support disabled
• No Mice: A mouse is not supported
• All Devices: All devices are supported (default)
Sets the OnBoard Serial Port settings
• Auto (default)
• Disable
• 3F8/COM1
• 2F8/COM2
• 3E8/COM3
• 2E8/COM4
336493-004
Description
Service Reference Guide, d200