Removing A 3.5" Hard Drive - HP Compaq d220 MT Reference Manual

The d240 and d248 chassis shown below has only three mounting screws on its front for securing
the lower drive cage.

6.7.5 Removing a 3.5" Hard Drive

1. Prepare the computer for disassembly
2. Remove both the right and left access panels
3. Remove the front bezel
4. Remove the diskette drive
5. Disconnect the power, and data cables from the back of all installed 3.5" drives.
6. Remove the lower drive cage
7. Remove the four screws, two from each side, that secure the drive in the drive cage 1.
8. Slide the drive out of the drive cage 2.
To replace the drive cage, reverse the removal procedure.
Service Reference Guide, d200
Removal and Replacement Procedures— Microtower Type 2 Chassis
(Section 6.1, "Preparation for
(Section 6.2, "Access
(Section 6.3, "Front Bezel").
(Section 6.7.3, "Removing a Diskette
(Section 6.7.4, "Removing the Lower Drive
336493-004
Disassembly").
Panel").
Drive").
Cage").
6–13