Entering A Setup Password - HP Compaq d220 MT Reference Manual

Entering a Power-On Password
To enter a power-on password, complete the following steps:
1. Turn on or restart the computer. If you are in Windows, click Start > Shut Down > Restart
the Computer.
2. When the key icon appears on the monitor, type your current password, then press
✎
Type carefully; for security reasons, the characters you type do not appear on the screen.
If you enter the password incorrectly, a broken key icon appears. Try again. After three
unsuccessful tries, you must turn off the computer, then turn it on again before you can continue.

Entering a Setup Password

If a setup password has been established on the computer, you will be prompted to enter it each
time you run Computer Setup.
1. Turn on or restart the computer. If you are in Windows, click Start > Shut Down > Restart
the Computer.
F10
2. Press the
✎
If you do not press the
again, and press the
3. When the key icon appears on the monitor, type the setup password, then press the
key.
✎
Type carefully; for security reasons, the characters you type do not appear on the screen.
If you enter the password incorrectly, a broken key icon appears. Try again. After three
unsuccessful tries, you must turn off the computer, then turn it on again before you can continue.
Changing a Power-On or Setup Password
1. Turn on or restart the computer. If you are in Windows, click Start > Shut Down > Restart
the Computer. To change the setup password, run Computer Setup.
2. When the key icon appears, type your current password, a slash (/) or alternate delimiter
character, your new password, another slash (/) or alternate delimiter character, and your
new password again as shown:
current password/new password/new password
✎
Type carefully; for security reasons, the characters you type do not appear on the screen.
Enter
3. Press the
The new password takes effect the next time you turn on the computer.
✎
Refer to the "National Keyboard Delimiter Characters" section in this chapter for information
about the alternate delimiter characters.
The power-on password and setup password may also be changed using the Security options in
Computer Setup.
Service Reference Guide, d200
key as soon as the monitor light turns green or the computer starts to boot.
F10
key at the appropriate time, you must turn the computer off, then on
F10
key again to access the utility.
key.
336493-004
Desktop Management
Enter.
Enter
3–5