Smeg SO4606APNR Manual page 56

Preliminary operations
1. Fill a jug or a container with approx. 2 litres
of water.
2. Open the appliance door.
3. Place the jug (or container) on the open
door.
The jug (or container) with the water
must have a gross weight lower than 5
kg.
4. Remove the loading wand from its holder.
• To remove the loading wand, press on the
front of the wand until the spring contracts,
then release.
• Touch the WAND button
display (positioned in the lower area
Pay attention to the distance to be
maintained so as not to be hit by the
wand projection.
914779675/A
or
on the
5. Place the end of the tube at the bottom of
the jug (or container).
6. Press the start
appliance reservoir with water.
7. Touch the CONFIRM
that you have finished filling the reservoir.
).
The appliance starts the function using the
parameters set.
Cleaning the water circuit
• When cleaning the reservoir and the
hydraulic circuit, leave the jug on the door
open with the loading wand inside. The
appliance cyclically discharges certain
quantities of water used for cleaning.
• During this process, the overflowing of water
inside the oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
End of water circuit cleaning
8. After completion of the cleaning process the
request to drain the water is shown on the
display.
9. Clean and dry any residual water inside the
oven cavity.
Reservoir draining
10. Open the door
11. Place a jug or container on the open door.
12. Remove the loading wand from its holder.
CLEANING AND MAINTENANCE - 123
button to start filling the
button to confirm