Smeg SO4606APNR Manual page 42

5. Touch the COOKING DURATION
button or the relevant value.
The duration of the Proving function can
be from a minimum of 1 minute to a
maximum of 12 hours and 59 minutes.
6. Scroll through the values and select the
required duration.
7. Touch the TEMPERATURE
relevant value.
8. Scroll through the values and select the
required cooking temperature (from 25°C
to 40°C).
9. Touch the CONFIRM
the settings.
10. Touch the START
Proving cycle.
When finished, a buzzer sounds briefly, which
can be deactivated by touching any point of the
display or by opening the door.
PLATE WARMING
Function that heats and keeps plates
warm. Position a baking tray on the
lowest shelf and put the plates on it to
warm.
1. Position the tray on the first shelf and place
the plates to be warmed at the centre of it.
Do not stack plates too high. Stack
plates a maximum of 5/6 high.
2. Select PLATE WARMING
914779675/A
button or the
button to confirm
button to start the
.
3. Touch the START
Plate warming function.
Unless otherwise set, the Plate warming
function has a maximum duration of 12
hours and 59 minutes.
The following can be set while the function is in
operation:
• the temperature
• the duration of the function
• a programmed function
duration different from the default one is set).
When finished, a buzzer sounds briefly, which
can be deactivated by touching any point of the
display or by opening the door.
STEAM REHEAT
The function reheats food that has
already been cooked and stored in the
refrigerator.
1. Put the food to be heated in a container.
2. Open the door.
3. Place the container on the rack in the first
shelf from the bottom.
4. Close the door.
5. Select STEAM REHEAT
6. Touch the COOKING DURATION
button or the relevant value.
7. Scroll through the values and select the
required cooking duration.
8. Touch the START
reservoir filling procedure.
The temperature of the steam reheat
cannot be changed by the user.
9. Proceed with reservoir filling as described
above.
10. Touch the START
Steam reheat function.
End of Steam reheat
At the end, "Function ended" displays and a
buzzer sounds briefly, which can be
deactivated by touching any point of the display
button to start the
(from 40°C to 80°C);
;
(only if a
.
button to start the
button to start the
USE - 109