Table of Contents
Advertisement
Turbo charge mode keeps the engine running after arriving at your destination
for a programmable period of 1, 3 or 5 minutes, This allows the vehicle's
engine time to conveniently cool down the turbo after you have left the vehicle.
To activate:
1. While the engine is running, pull up the hand brake and place the
transmission gear in the park position.
2. Before turning off the engine, press and release
same time.
-- The LED will flash indicating the remote start has entered the turbo charge
mode.
3. Take the "Ignition Key" from the key cylinder.
-- Engine keeps running. --
4. Exit and secure the vehicle.
-- Engine continues running until the pre-programmed time elapsed. --
NOTE: This feature only applies to vehicles with Turbo Engines.
E. TIMER / TEMPERATURE START:
This unit can be programmed to start and run the engine every 3 hours or
punctually at the same time next morning, the engine will run for the
programmed running time and then shut down.
IMPORTANT: Timer Start should be used only in open areas, never start and run the
vehicle in on enclosed space such as a garage or carport.
3 hours timer start with Temperature-control OFF: This feature is design for
an extreme cold climate usage. The system will auto start the vehicle every 3
hours, to prevent engine freezing and hard to start.
A MAXIMUM OF SIX CYCLES CAN OCCUR.
3 hours timer start with Temperature-control:
If you installed the optional Temperature Sensor and programmed the
temperature ON to operate. The system can be programmed to automatically
start the vehicle engine whenever the temperature inside the vehicle reaches
or drops below the preprogrammed temperature level.
monitor the air temperature every 3 hour and will only start the engine during
extreme cold temperatures. There are three temperature levels to choose from.
Daily Timer Start: The feature is very useful for the driver who wants to run
the vehicle punctually at the same time next morning. Before set-up of the
"Daily Timer Start", you should set you time for engine start.( see Timer Setting
/ Timer set-up for "Daily Timer Start, page 16)
ENTER:
1. Press the
button once to remote start the vehicle.
2. Immediately depress the
3-a. 3 Hours Timer Start: Rapidly depresses the
buttons, if you program
light will flash (3) times. The siren or horn chirps (3) times. The vehicle is now
programmed to start every (3) hours.
button once, within 2 seconds
button (or depresses
+
buttons = Start / Stop button.) The parking
24
and
buttons at the
The system will
+
Advertisement
Table of Contents
