To Install Pc Card Support - HP OmniBook 800 Evaluator Manual
Corporate evaluator’s guide
Hide thumbs
Also See for OmniBook 800:
- Installation and setup manual (88 pages) ,
- User manual (79 pages) ,
- Getting started manual (54 pages)
Table of Contents
Advertisement
9. Set the following values for MIDI and click OK.
MPU-401 I/O Address
MIDI Output
10. Set the following values for Windows Audio Options and click OK.
I/O Address
Interrupt Level
DMA Channel
DMA 2
11. Click OK twice.
12. Type Exit and remove the diskette from drive A.
13. Shutdown OS/2 and restart the OmniBook by pressing Ctrl+Alt+Delete when
prompted.
To install PC card support
Steps 1-9 are necessary only if you did not install PC card support during OS/2 Warp
installation process.
Requirements
OmniBook 800 with OS/2 Warp 4.0 installed.
OS/2 Warp installation CD-ROM.
OmniBook external CD-ROM.
OmniBook 800 driver for PC card support.
Location: OS/2 Device Driver Repository World Wide Web site at
http://service.software.ibm.com/os2ddpak/html/pcmciaso/hewlett_/index.htm
1. Restart the OmniBook.
2. Open OS/2 System, System Setup, then Install/Remove.
3. Double-click on Selective Install.
4. Click Multimedia Support, Remove, then OK.
5. Click Next, then click PCMCIA Support.
6. In the PCMCIA Support Window, select Ambra TS30AS. If PCMCIA hard disks or
FLASH cards will be used, check the appropriate options, then click OK.
7. Click Next twice.
330
Internal ESFM
220
5
1
5
Using OS/2 Warp 4.0
Installing OS/2 Warp 4.0
6-9
Advertisement
Table of Contents
