To Open The Cd-Rom Drive Manually; To Install Drivers For The Zip Drive - HP OmniBook 3000 Reference Manual
Hp omnibook 3000: reference guide
Hide thumbs
Also See for OmniBook 3000:
- Service manual (86 pages) ,
- User handbook manual (59 pages) ,
- User manual (32 pages)
Table of Contents
Advertisement
To open the CD-ROM drive manually
If you lose power to the OmniBook, or if you have removed the CD-ROM module
from the OmniBook, you can manually open the CD-ROM drive to remove a CD.
Insert a straightened paper clip into the recessed hole, as shown.
To install drivers for the Zip drive
The Zip drive comes with a CD containing drivers and software for the Zip drive.
Follow these steps to set up this software.
1. Set up a CD-ROM drive for your OmniBook. (The Zip drive does not have to be
installed at this time.)
2. Insert the Zip CD in the CD-ROM drive.
3. Click Start, Run, then type drive:\install and click OK, where drive is the drive
letter of the CD-ROM drive. For example, type d:\install if the CD-ROM is drive D.
This installs the Zip software so it's ready whenever you insert the Zip drive.
To obtain the latest versions of Zip drivers and software, access the Iomega website
at http://www.iomega.com/.
Making Connections
Using OmniBook Plug-In Modules
5-7
Advertisement
Table of Contents
Troubleshooting
