Figure 61 Static Route: Add; Table 36 Static Route: Add - ZyXEL Communications P-870HW-51a v2 User Manual

Figure 61 Static Route: Add

The following table describes the labels in this screen.

Table 36 Static Route: Add

LABEL
Destination IP
Address
IP Subnet Mask
Use Interface
Use Gateway IP
Address
Back
Apply
Cancel
P-870HW-51a v2 User's Guide
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the IP subnet mask here.
Select a predefined interface through which the traffic is sent. If you select a WAN
interface using PPPoE you must specify the gateway IP address.
Select this option and enter the IP address of the next-hop gateway. The gateway is
a router or switch on the same segment as your ZyXEL Device's interface(s). The
gateway helps forward packets to their destinations.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
Chapter 10 Static Route
115