Light Source/Temperature/Filter Indicators; When An Indicator Lights Up - Panasonic PT-MZ570 Operating Instructions Manual

Chapter 6 Maintenance — Light source/temperature/filter indicators

Light source/temperature/filter indicators

When an indicator lights up

If a problem occurs inside the projector, the slight source indicator <LIGHT>/temperature indicator <TEMP>/filter
indicator <FILTER> will inform you by illuminating or blinking. Check the status of the indicators and take following
measures.
Attention
f When switching off the projector to deal with problems, make sure to follow the procedure in "Switching off the projector" (x page 66).
Light source indicator <LIGHT>
Indicator status
Some of the elements of the light
Status source are defective and the light
output has decreased.
Solution
f Turn the <MAIN POWER> switch to <OFF> (x page 66), and turn on the power again.
Note
f If the light source indicator <LIGHT> continues to light or blink even after the measure is taken, set the <MAIN POWER> switch to <OFF>,
and ask your dealer for repair.
f When the projector is in projecting state and there is no notification by illuminating or blinking in red, the light source indicator <LIGHT> is
turned off.
Lighting in red
The light source does not light up, or the light source turns off while the
projector is in use.
Light source indicator <LIGHT>
Temperature indicator <TEMP>
Filter indicator <FILTER>
Blinking in red
(2 times)
Blinking in red
(3 times)
ENGLISH - 197