Chapter 5 Maintenance — Light source/temperature/filter indicators
Light source/temperature/filter indicators
When an indicator lights up
If a problem occurs inside the projector, the light source indicators <LIGHT1>/<LIGHT2>, temperature indicator
<TEMP>, or filter indicator <FILTER> will inform you by lighting or blinking in red. Check the status of the
indicators and take following measures.
Attention
f When switching off the projector to deal with problems, make sure to follow the procedure in "Switching off the projector" (x page 66).
Light source indicators <LIGHT1>/<LIGHT2>
Indicator status
Status
The light source does not light up, or the light source turns off while the projector is in use.
Cause
Solution
f Turn the <MAIN POWER> switch to <OFF> (x page 66), and turn on the power again.
Note
f If the light source indicators <LIGHT1>/<LIGHT2> are still lit or blinking after taking the measures, ask your dealer for repair.
f The light source indicator corresponding to the light source being lit will light up in green if the projector is in projection mode and there is no
indication of problem by lighting or blinking in red.
188 - ENGLISH
Light source indicator <LIGHT1>
Light source indicator <LIGHT2>
Blinking in red
(2 times)
Temperature indicator <TEMP>
Filter indicator <FILTER>
Blinking in red
(3 times)
―