[Dc Out]; [Status] - Panasonic PT-MZ570 Operating Instructions Manual

[DC OUT]

Set the power supply function of the <DC OUT> terminal.
1) Press as to select [DC OUT].
2) Press qw to select an item.
[ON]
[OFF]
Note
f When [DC OUT] is set to [ON], the power is supplied even in the standby state or ready state in the following cases.
g When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], and [QUICK STARTUP] is
set to [ON], and then the projector goes into the standby state by pressing the power <v/b> button
g When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [POWER MANAGEMENT] is set to [READY], and no signal is
detected and the projector goes into the ready state
f When an external device exceeding the rating (DC 5 V, maximum 2 A) is connected to the <DC OUT> terminal while this function is set to
[ON], an error is detected and the power supply will be stopped. At this time, [ERROR] is displayed in [DC OUT]. Disconnect the external
drive and turn on the projector again when [ERROR] is displayed.

[STATUS]

Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE]
[SERIAL NUMBER]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
[CONTINUOUS LIGHTING
TIME]
[MAIN/SUB VERSION]
[NETWORK VERSION]
[INTAKE AIR TEMP.]
[EXHAUST AIR TEMP.]
[LIGHT TEMP. 1]
*1
[LIGHT TEMP. 2]
*1
[SELF TEST]
[INPUT]
[SIGNAL NAME]
[MEMORY NO.]
[ON COUNT]
[NUMBER OF REGISTERED
SIGNAL]
[COOLING CONDITION]
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[REMOTE1 STATUS]
[EMULATE]
126 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Enables the power supply function. Power is supplied to the external device connected to the <DC
OUT> terminal.
Disables the power supply function. The power is not supplied even if an external device is connected
to the <DC OUT> terminal.
Displays the projector type and serial number of the projector.
Displays the serial number of the projector.
Displays the runtime of the projector.
Displays the runtime of the light source.
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
Displays the main and sub versions of the firmware of the projector.
Displays the network version of the firmware of the projector.
Displays the status of the intake air temperature of the projector.
*1
Displays the status of the exhaust air temperature of the projector.
*1
Displays the temperature status for the front block of the light source (on the lens side).
Displays the temperature status for the rear block of the light source (on the air exhaust port side).
Displays the status of the projector.
Displays the input terminal currently selected.
Displays the input signal name.
Displays the memory number of the input signal.
[POWER ON TIMES]
Displays the number of registered signals.
Displays the set cooling conditions.
Displays the control status of the REMOTE1.
Displays the setting in the [PROJECTOR SETUP] menu → [RS-232C] → [EMULATE].
Displays the number of times the power is turned on.